brunswick pool table assembly instructions

Stretch cloth tightly toward Foot End of table, tacking on 3' centers all the way across (17).ġ8. Tack balance of Head End on 3' centers holding the proper margin (16).ġ7. Tack all of Left Side on 3' centers holding to proper margin (15).ġ6. Stretch cloth tightly from (12) and (13) toward (14) and tack securely.ġ5. Stretch cloth firmly from (11) to Foot End of table and tack at (13).ġ4.

Pull cloth from (11) toward (12) and tack securely, holding proper margin.ġ3. At Head End of table, tack cloth at (11), holding the proper margin.ġ2. Be sure to tack cloth to undercut of slate frame.ġ1. Stretching cloth tightly across the table from (9) repeat the above operation at (10). Complete tacking of cloth to side pocket opening, making sure that cloth is tacked to undercut of slate frame.ġ0. Grasp cloth firmly above this slit, pull cloth into side pocket opening and tack to undercut of slate frame. At (9), cut a short slit in cloth at edge centered with side pocket opening. Repeat operation 7, stretching cloth from (6) and toward side pocket from (4) and tack at (8).ĩ. On right side of table, grasp cloth firmly, stretch across table from (5) and toward side pocket from (2) and tack at (7).Ĩ. Repeat operation 5, stretching cloth from (3) and tacking at (6).ħ. On left side, stretch cloth tightly from (1) toward side pocket opening and tack securely at (5).Ħ. Stretching cloth across table from (3) and pulling from (2), tack cloth at (4).ĥ. Stretch cloth from (1) to (3) and tack securely, maintaining proper margin on the left side of the table.Ĥ. Stretch cloth across the table and staple securely at (2) again using 4 staples as indicated above.ģ. Staple cloth securely to slate frame at (1) with 4 staples approximately 1' apart.Ģ. Leave only enough cloth at head end and left to permit tracking, leaving balance of the cloth hanging on the foot end and right side. Lay the bed cloth over top of slate, play side up.

The rails should be 6' wide.Ī: To make perfect cuts, simply make a one inch cut into the cloth, then just rip it! Woven cloth easily tears in a straight line.ġ. Other tables have staples securing the cloth.Ī: The smooth side is up, the fuzzy side is down.Ī: Use the drawings to the right to see where to 'snip & rip' the cloth for the rails. On some tables, the cloth is held in place by a band of glue around the edges of the slate. Installation instructions are also included.Ī: That depends. If you feel comfortable using a wrench and a stapler, it should be a fun project.Ī: You receive one piece of cloth that is sufficient to cover the bed of the table and the six rails. Each strip needs to be six inches wide.Ī: Simply measure between the rails and refer to the chart to the right.Ī: Yes. To cut the cloth for your rails, 'snip & rip' six strips from the location, indicated by the following charts for your table size and cloth type. To download in PDF format please click here.

Brunswick pool table assembly instructions